Module 4 · Lesson 4 of 6 · 3 minutes

Daily cleaning, earmoulds, tubing and wax filters

A few minutes of cleaning each day stops most hearing aid problems. Learn what to clean, how, and what to report.

Every day

Daily clean for all hearing aids

  1. Take the hearing aids out and switch them off or place them on the charger after cleaning.
  2. Wipe the hearing aid and earmould or dome with a dry, soft cloth, or the wipes the provider recommends.
  3. Brush the microphone openings and sound outlet with the small brush supplied, holding the aid so debris falls away from it.
  4. Look for wax, moisture, cracks or damage.
  5. Put the hearing aids in their labelled case or charger in the agreed place.

Earmoulds and tubing (behind-the-ear aids)

Checking hearing aid tubing Two earmould tubes side by side. The tube marked 'Good' is clear, soft and smooth. The tube marked 'Needs attention' is yellow and stiff, has a crack, and has water droplets inside, which block sound. ✓ Good Clear, soft, no cracks ✕ Needs attention Yellow, hard,cracked or wet
Check tubing every day. Report hard, yellow, split or wet tubing to the hearing aid provider.
  • Check the tube every day. It should be clear, soft and firmly attached.
  • Water droplets in the tube block sound. Many providers supply a small air puffer to blow them out. Use it as you have been shown.
  • Hard, yellow, split or squashed tubing needs replacing. NHS audiology services and private providers can retube, and some offer training so care staff can do it.
  • Some providers advise washing the earmould in warm soapy water once a week. This must only be done after detaching it from the hearing aid, and only if you have been shown how. Dry it thoroughly and blow the tube through before reattaching.

Domes and wax filters (receiver-in-canal and in-the-ear aids)

  • Domes should be clean and soft. Replace them when they are dirty, stiff, split or as often as the manufacturer advises.
  • Wax filters (wax guards) catch wax before it reaches the speaker. Change them when blocked, using the tool supplied and following the manufacturer’s instructions.
  • Use only the domes and filters made for that hearing aid. Sizes vary.

Check your understanding

Your answers are not recorded anywhere except, if possible, on this device.

Which of these is safe to use on the hearing aid itself?
What should you do if you notice tubing is hard, yellow or split?

Clinical review: pending — drafted November 2026 from the references listed. Awaiting review by a qualified audiologist.