Module 4 · Lesson 3 of 6 · 3 minutes

Putting hearing aids in and taking them out

Step-by-step guidance for putting in and removing the main types of hearing aid comfortably and safely.

Before putting hearing aids in

  1. Wash your hands.
  2. Check you have the right aid for the right ear (red = right, blue = left).
  3. Check the aid is clean, the tubing or dome is not blocked or damaged, and the battery or charge is good.
  4. Switch it on. Close the battery door, or take it out of the charger. Many aids play a short tune or have a short delay before they start.

Behind-the-ear aid with earmould

  1. Hold the earmould between your thumb and first finger, with the long canal part pointing towards the ear canal.
  2. Gently place the canal part into the entrance of the ear canal. Ease it in with a slight twisting movement until it feels snug.
  3. Tuck the top part of the earmould into the upper fold of the ear.
  4. Lift the hearing aid over the top of the ear so it sits behind the ear.
  5. Check it feels comfortable, there is no whistling, and ask the resident how it sounds.

Receiver-in-canal aid with dome

  1. Place the hearing aid case over the top of the ear so it sits behind the ear.
  2. Hold the thin wire where it bends towards the ear, close to the dome.
  3. Gently push the dome into the ear canal until the wire lies flat against the side of the head.
  4. If there is a small retention line, tuck it into the bowl of the ear.
  5. Check comfort and ask how it sounds.

Custom in-the-ear aid

  1. Hold the aid by its edges with the battery door or removal thread at the bottom.
  2. Place the canal tip into the ear canal and gently push and rotate until it sits flush in the ear.
  3. Check comfort and ask how it sounds.

Taking hearing aids out

  • BTE: lift the aid from behind the ear, then hold the earmould (not the tube) and gently ease it out.
  • RIC: lift the case from behind the ear, then hold the wire close to the ear, or the retention line, and gently ease the dome out.
  • ITE: hold the edges, or use the removal thread, and ease it out.

Then switch off (open the battery door) or put it on the charger, clean it, and put it in its labelled case.

Check your understanding

Your answers are not recorded anywhere except, if possible, on this device.

When taking out a behind-the-ear hearing aid with an earmould, what should you hold?

You have just put in Mrs Hall's hearing aid and it starts whistling.

What is the most likely cause, and what should you do first?

Clinical review: pending — drafted November 2026 from the references listed. Awaiting review by a qualified audiologist.